6 TONNE COMBO SPREADER

Tough and versatile.

With the same practical design and easy to use operation that all SAM’s are known for, the SAM Combo Spreaders provide extra versatility around what you are able to spread.

They are capable of spreading chemical fertiliser including; superphosphate, urea and lime. But will also spread most organic product like chicken and pig manure, screw-pressed effluent and sand.

Sizes come in 3.8, 6 & 9 tonne. All come standard with an 800mm floor.

Keep it simple with a standard hydraulic clutch to ground drive, add load cells, or upgrade to the latest smart, accurate Topcon control system.

Enquire Now

SAM Spreader In Action

Features

Stainless back end

Stainless back end

The bulk of the back end is constructed from stainless steel. This cuts out rust and means the life of your running gear is extended. The flat discs, vanes and spinner tubes are all stainless. They connect to a pair of extremely reliable hydraulic motors. The roller bearings are easily adjustable for you and keep discs firm.

The paintwork may outlast you!

The paintwork may outlast you!

Every SAM has an advanced new paint procedure. This application has been chosen for its hard-wearing toughness. They are firstly blasted with a steel-grit, then a zinc spray is applied (thermal-arc), a primer coat then the two pot epoxy paint. Mega-solid!

Tough rust resistant hopper

Tough rust resistant hopper

These plastic bins have shown themselves to be very strong and reliable. They are made from UV-protected polyethylene. Fertiliser can be extremely corrosive and the SAM bin prevents that by being rust-free and easy clean. Fertiliser slips down the sides easily and washes off well.

Consistent spread control

Consistent spread control

Setting the rate you wish to spread is simply by rear door adjustment. The double spinner design gives a nice, accurate, even spread pattern for a wide range of product.

Smart, accurate weighing

Smart, accurate weighing

When purchasing your Spreader you can add electronic weigh scales. This mean you can weigh the fertiliser in your bin at any point. They can also be zeroed out. Further information is below. Note: Weigh scales cannot be fitted retrospectively to Spreaders.

Topcon control system

Topcon control system

You can also add a Topcon control system to replace the standard ground drive. This gives hydraulic floor speed rate and control. This technology means the correct application rate is applied regardless of changes in forward speed or changes in product density. Gives peace of mind for accuracy and reporting.

Mudguards for added protection

Mudguards for added protection

Standard on all tandem axle machines. SAM mudguards are made from UV-protected, high strength polyethylene. Cleaning and chips to chassis are reduced and they hold up well to abrasive chemical fertilisers.

Heavy-duty rubber belt

Heavy-duty rubber belt

The 800mm wide rubber floor is two-ply rubber, riveted into galv steel bars, then welded onto a high-strength chain. Stainless steel skirts run along both sides to prevent striping.

Coupling with swivel

Coupling with swivel

A fixed coupling is standard across 4 and 5 tonne Spreaders. These can be upgraded to a swivel coupling if need be. Great if you have large loads and varied terrain. 6 tonne and above have the heavy swivel coupling as standard. When you are using an Auto Hitch you’ll require a donut eye on the coupling.

Filtering mesh

Filtering mesh

This protective mesh protects the belt and running gear from large objects causing damage.

Roll top cover

Roll top cover

These simple to use roll out covers have a heavy-duty canvas on a sturdy framework with a simple bungy system. The cover is rolled up by the handle and tucked out of the way when you are not using it. The roll-top is located at the rear of the machine so that your Spreader is able to be loaded from both sides.

Buying Tools

Enquire now